Configuring Rfid Tag Tracking - Cisco 2100 Series Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
8.
Use these commands to obtain CDP debug information for the controller.
1.
2.

Configuring RFID Tag Tracking

The controller enables you to configure radio-frequency identification (RFID) tag tracking. RFID tags
are small wireless devices that are affixed to assets for real-time location tracking. They operate by
advertising their location using special 802.11 packets, which are processed by access points, the
controller, and the location appliance.
The controller supports tags from AeroScout, WhereNet, and Pango (an InnerWireless company). Some
of the tags from these vendors comply with Cisco Compatible Extensions for RFID Tags. See
for details. The location appliance receives telemetry and chokepoint information from tags that are
compliant with this CCX specification.
OL-17037-01
To see a list of all CDP neighbors for all access points connected to the controller, enter these
commands:
show ap cdp neighbors all
show ap cdp neighbors detail all
Information similar to the following appears when you enter show ap cdp neighbors all:
AP Name AP IP
-------- --------
AP0013.601c.0a0 10.76.108.123
AP0013.601c.0b0 10.76.108.111
AP0013.601c.0c0 10.76.108.125
Information similar to the following appears when you enter show ap cdp neighbors detail all:
AP Name: AP0013.601c.0a0
AP IP Address: 10.76.108.125
----------------------------------
Device ID: 6500-1
Entry address(es): 10.76.108.207
Platform: cisco WS-C6506-E,
Interface: Port - 1, Port ID (outgoing port): GigabitEthernet1/26
Holdtime: 157 sec
Version:
Cisco Internetwork Operating System Software
(s72033_rp-PSV-M), Version 12.2(18)SXD5, RELEASE SOFTWARE (fc3) Technical Support:
http://www.cisco.com/techsupport Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Fri 13-Ma
The access point sends CDP neighbor information to the controller only when the
Note
information changes.
To obtain debug information related to CDP packets, enter this command:
debug cdp packets
To obtain debug information related to CDP events, enter this command:
debug cdp events
Neighbor Name Neighbor IP
------------- -----------
6500-1 10.76.108.207
6500-1 10.76.108.207
6500-1 10.76.108.207
Capabilities: Router Switch IGMP
IOS (tm) s72033_rp Software
Cisco Wireless LAN Controller Configuration Guide
Configuring RFID Tag Tracking
Neighbor Port
-------------
GigabitEthernet1/26
GigabitEthernet1/27
GigabitEthernet1/28
Table 4-3
4-79