Configuring 802.11N Parameters; Using The Gui To Configure 802.11N Parameters - Cisco 2100 Series Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
To save your changes, enter this command:
Step 10
save config
To view the configuration settings for the 802.11a or 802.11b/g band, enter this command:
Step 11
show {802.11a | 802.11b}
Information similar to the following appears:
802.11a Network............................... Enabled
11nSupport.................................... Enabled
802.11a Operational Rates
802.11a 6M Rate.............................. Mandatory
802.11a 9M Rate.............................. Supported
802.11a 12M Rate............................. Mandatory
802.11a 18M Rate............................. Supported
802.11a 24M Rate............................. Mandatory
802.11a 36M Rate............................. Supported
802.11a 48M Rate............................. Supported
802.11a 54M Rate............................. Supported
...
Beacon Interval.................................. 100
...
Default Channel............................... 36
Default Tx Power Level........................ 1
DTPC Status................................... Enabled
Fragmentation Threshold....................... 2346
...

Configuring 802.11n Parameters

This section provides instructions for managing 802.11n devices such as the Cisco Aironet 1140 and
1250 Series Access Points on your network. The 802.11n devices support the 2.4- and 5-GHz bands and
offer high-throughput data rates.
The 802.11n high-throughput rates are available only on 1140 and 1250 series access points for WLANs
Note
using WMM with no Layer 2 encryption or with WPA2/AES encryption enabled.
For information on configuring radio resource management (RRM) parameters or statically assigning
Note
radio parameters for 802.11n access points, refer to

Using the GUI to Configure 802.11n Parameters

Using the controller GUI, follow these steps to configure 802.11n parameters.
Click Wireless > 802.11a/n or 802.11b/g/n > High Throughput (802.11n) to open the 802.11n (5 GHz
Step 1
or 2.4 GHz) High Throughput page (see
OL-17037-01
802.11a Low Band........................... Enabled
802.11a Mid Band........................... Enabled
802.11a High Band.......................... Enabled
Chapter 11.
Figure 4-3).
Cisco Wireless LAN Controller Configuration Guide
Configuring 802.11n Parameters
4-17