Configuring Quality of Service
To define the peak data rate for TCP traffic on a per user basis, enter the rate in Kbps in the Burst Data
Step 7
Rate field. You can enter a value between 0 and 60,000 Kbps (inclusive). A value of 0 imposes no
bandwidth restriction on the QoS role.
Note
To define the average real-time rate for UDP traffic on a per user basis, enter the rate in Kbps in the
Step 8
Average Real-Time Rate field. You can enter a value between 0 and 60,000 Kbps (inclusive). A value of
0 imposes no bandwidth restriction on the QoS role.
To define the peak real-time rate for UDP traffic on a per user basis, enter the rate in Kbps in the Burst
Step 9
Real-Time Rate field. You can enter a value between 0 and 60,000 Kbps (inclusive). A value of 0 imposes
no bandwidth restriction on the QoS role.
Note
Step 10
Click Apply to commit your changes.
Step 11
Click Save Configuration to save your changes.
To apply a QoS role to a guest user, follow the steps in the
Step 12
Users" section on page
Using the CLI to Configure QoS Roles
Follow these steps to configure QoS roles using the controller CLI.
To create a QoS role for a guest user, enter this command:
Step 1
config netuser guest-role create role_name
Note
To configure the bandwidth contracts for a QoS role, enter these commands:
Step 2
•
•
•
Cisco Wireless LAN Controller Configuration Guide
4-50
The Burst Data Rate should be greater than or equal to the Average Data Rate. Otherwise, the
QoS policy may block traffic to and from the wireless client.
The Burst Real-Time Rate should be greater than or equal to the Average Real-Time Rate.
Otherwise, the QoS policy may block traffic to and from the wireless client.
5-30.
If you want to delete a QoS role, enter this command:
config netuser guest-role delete role_name
config netuser guest-role qos data-rate average-data-rate role_name rate—Configures the
average data rate for TCP traffic on a per user basis.
config netuser guest-role qos data-rate burst-data-rate role_name rate—Configures the peak
data rate for TCP traffic on a per user basis.
The Burst Data Rate should be greater than or equal to the Average Data Rate. Otherwise,
Note
the QoS policy may block traffic to and from the wireless client.
config netuser guest-role qos data-rate average-realtime-rate role_name rate—Configures the
average real-time rate for UDP traffic on a per user basis.
Chapter 4
Configuring Controller SettingsWireless Device Access
"Using the GUI to Configure Local Network
OL-17037-01