Cisco 2100 Series Configuration Manual page 114

Configuring 802.11n Parameters
Figure 4-3
Check the 11n Mode check box to enable 802.11n support on the network. The default value is enabled.
Step 2
To specify the modulation and coding scheme (MCS) rates at which data can be transmitted between the
Step 3
access point and the client, check the check boxes of the desired rates. These data rates, which are
calculated for a 20-MHz channel width using a short guard interval, are available:
• 0 (7 Mbps)
• 1 (14 Mbps)
2 (21 Mbps)
•
3 (29 Mbps)
•
4 (43 Mbps)
•
5 (58 Mbps)
•
6 (65 Mbps)
•
7 (72 Mbps)
•
8 (14 Mbps)
•
9 (29 Mbps)
•
10 (43 Mbps)
•
11 (58 Mbps)
•
12 (87 Mbps)
•
Cisco Wireless LAN Controller Configuration Guide
4-18
802.11n (2.4 GHz) High Throughput Page
Chapter 4 Configuring Controller SettingsWireless Device Access
OL-17037-01