Using The Cli To Upload Radio Core Dumps - Cisco 2100 Series Configuration Manual

Autonomous Access Points Converted to Lightweight Mode
In the File Name field, enter the name of the radio core dump file.
Step 6
Note
If you chose FTP as the Transfer Mode, follow these steps:
Step 7
a.
b.
c.
Click Upload to upload the radio core dump file from the controller. A message appears indicating the
Step 8
status of the upload.

Using the CLI to Upload Radio Core Dumps

Using the controller CLI, follow these steps to upload the radio core dump file to a TFTP or FTP server.
To transfer the file from the controller to a TFTP or FTP server, enter these commands:
Step 1
•
•
•
•
•
Step 2 If you are using an FTP server, also enter these commands:
•
•
•
To view the updated settings, enter this command:
Step 3
transfer upload start
When prompted to confirm the current settings and start the software upload, answer y.
Step 4
Cisco Wireless LAN Controller Configuration Guide
7-30
The filename that you enter should match the filename generated on the controller. You can
determine the filename on the controller by entering the show ap crash-file command.
In the Server Login Username field, enter the FTP server login name.
In the Server Login Password field, enter the FTP server login password.
In the Server Port Number field, enter the port number of the FTP server. The default value for the
server port is 21.
transfer upload mode {tftp | ftp}
transfer upload datatype radio-core-dump
transfer upload serverip server_ip_address
transfer upload path server_path_to_file
transfer upload filename filename
The filename that you enter should match the filename generated on the controller. You can
Note
determine the filename on the controller by entering the show ap crash-file command.
transfer upload username username
transfer upload password password
transfer upload port port
The default value for the port parameter is 21.
Note
Chapter 7 Controlling Lightweight Access Points
OL-17037-01