Using The Gui To Configure Cisco Discovery Protocol - Cisco 2100 Series Configuration Manual

Configuring Cisco Discovery Protocol

Using the GUI to Configure Cisco Discovery Protocol

Follow these steps to configure CDP using the controller GUI.
Click Controller > CDP > Global Configuration to open the CDP > Global Configuration page (see
Step 1
Figure
Figure 4-28
Check the CDP Protocol Status check box to enable CDP on the controller or uncheck it to disable this
Step 2
feature. The default value is checked.
From the CDP Advertisement Version drop-down box, choose v1 or v2 to specify the highest CDP
Step 3
version supported on the controller. The default value is v1.
In the Refresh-time Interval field, enter the interval at which CDP messages are to be generated. The
Step 4
range is 5 to 254 seconds, and the default value is 60 seconds.
In the Holdtime field, enter the amount of time to be advertised as the time-to-live value in generated
Step 5
CDP packets. The range is 10 to 255 seconds, and the default value is 180 seconds.
Click Apply to commit your changes.
Step 6
Click Save Configuration to save your changes.
Step 7
Perform one of the following:
Step 8
•
Cisco Wireless LAN Controller Configuration Guide
4-72
4-28).
CDP > Global Configuration Page
To enable or disable CDP on a specific access point, follow these steps:
Click Wireless > Access Points > All APs to open the All APs page.
a.
Click the link for the desired access point.
b.
Click the Advanced tab to open the All APs > Details for (Advanced) page (see
c.
Chapter 4 Configuring Controller SettingsWireless Device Access
Figure 4-29).
OL-17037-01