Configuring The Controller For Hybrid Reap - Cisco 2100 Series Configuration Manual

Configuring Hybrid REAP
Refer to the sample configuration below to configure the switch to support the hybrid-REAP access
Step 2
point.
In this sample configuration, the hybrid-REAP access point is connected to trunk interface FastEthernet
1/0/2 with native VLAN 100. The access point needs IP connectivity on the native VLAN. The remote
site has local servers/resources on VLAN 101. A DHCP pool in created in the local switch for both
VLANs in the switch. The first DHCP pool (NATIVE) will be used by the hybrid-REAP access point,
and the second DHCP pool (LOCAL-SWITCH) will be used by the clients when they associate to a
WLAN that is locally switched. The bolded text in the sample configuration illustrates these settings.
Note
Sample local switch configuration:
ip dhcp pool NATIVE
network 10.10.100.0 255.255.255.0
default-router 10.10.100.1
!
ip dhcp pool LOCAL-SWITCH
network 10.10.101.0 255.255.255.0
default-router 10.10.101.1
!
interface FastEthernet1/0/1
description Uplink port
no switchport
ip address 10.10.98.2 255.255.255.0
spanning-tree portfast
!
interface FastEthernet1/0/2
description the Access Point port
switchport trunk encapsulation dot1q
switchport trunk native vlan 100
switchport trunk allowed vlan 100,101
switchport mode trunk
spanning-tree portfast
!
interface Vlan100
ip address 10.10.100.1 255.255.255.0
ip helper-address 10.10.100.1
!
interface Vlan101
ip address 10.10.101.1 255.255.255.0
ip helper-address 10.10.101.1
end

Configuring the Controller for Hybrid REAP

This section provides instructions for configuring the controller for hybrid REAP using either the GUI
or the CLI.
Cisco Wireless LAN Controller Configuration Guide
13-6
The addresses in this sample configuration are for illustration purposes only. The addresses that
you use must fit into your upstream network.
Chapter 13 Configuring Hybrid REAPWireless Device Access
OL-17037-01