Configuring RRM
Using the GUI to Configure Dynamic Channel Assignment
Using the controller GUI, follow these steps to specify the channels that the dynamic channel assignment
(DCA) algorithm considers when selecting the channels to be used for RRM scanning. This functionality
is helpful when you know that the clients do not support certain channels because they are legacy devices
or they have certain regulatory restrictions.
To disable the 802.11a or 802.11b/g network, follow these steps:
Step 1
a.
b.
c.
Click Wireless > 802.11a/n or 802.11b/g/n > RRM > DCA to open the 802.11a (or 802.11b/g) > RRM
Step 2
> Dynamic Channel Assignment (DCA) page (see
Figure 11-4
Cisco Wireless LAN Controller Configuration Guide
11-12
Click Wireless > 802.11a/n or 802.11b/g/n > Network to open the 802.11a (or 802.11b/g) Global
Parameters page.
Uncheck the 802.11a (or 802.11b/g) Network Status check box.
Click Apply to commit your changes.
802.11a > RRM > Dynamic Channel Assignment (DCA) Page
Chapter 11
Configuring Radio Resource ManagementWireless Device Access
Figure
11-4).
OL-17037-01