Cisco 2100 Series Configuration Manual page 393

Chapter 7 Controlling Lightweight Access Points
To add access points to the provision list, enter this command:
Step 6
config certificate lsc ap-provision auth-list add AP_mac_addr
Note
Note
To configure the number of times that the access point attempts to join the controller using an LSC before
Step 7
the access point reverts to the default certificate (MIC or SSC), enter this command:
config certificate lsc ap-provision revert-cert retries
where retries is a value from 0 to 255, and the default value is 3.
If you set the number of retries to a non-zero value and the access point fails to join the controller using
an LSC after the configured number of retries, the access point reverts to the default certificate.
If you set the number of retries to 0 and the access point fails to join the controller using an LSC, the
access point does not attempt to join the controller using the default certificate.
Note
To provision the LSC on the access point, enter this command:
Step 8
config certificate lsc ap-provision {enable | disable}
To view the LSC summary, enter this command:
Step 9
show certificate lsc summary
Information similar to the following appears:
LSC Enabled.......................................... Yes
LSC CA-Server........................................ http://10.0.0.1:8080/caserver
LSC AP-Provisioning.................................. Yes
Provision-List................................... Not Configured
LSC Revert Count in AP reboots................... 3
LSC Params:
Country.......................................... 4
State............................................ ca
City............................................. ss
Orgn............................................. org
Dept............................................. dep
Email............................................ dep@co.com
KeySize.......................................... 390
LSC Certs:
CA Cert.......................................... Not Configured
RA Cert....................................... Not Configured
OL-17037-01
To remove access points from the provision list, enter this command: config certificate lsc
ap-provision auth-list delete AP_mac_addr.
If you configure an access point provision list, only the access points in the provision list are
provisioned when you enable AP provisioning (in
point provision list, all access points with a MIC or SSC certificate that join the controller are
LSC provisioned.
If you are configuring LSC for the first time, Cisco recommends that you configure a non-zero
value.
Autonomous Access Points Converted to Lightweight Mode
Step 8). If you do not configure an access
Cisco Wireless LAN Controller Configuration Guide
7-21