Cisco 2100 Series Configuration Manual page 602

Wireless lan controller
Hide thumbs Also See for 2100 Series:
Table of Contents

Advertisement

Overriding RRM
Note
To save your settings, enter this command:
Step 7
save config
Step 8
Repeat
and power level.
To re-enable the access point radio, enter this command:
Step 9
config {802.11a | 802.11b} enable Cisco_AP
Step 10
To have the controller send the access point radio admin state immediately to WCS, enter this command:
config {802.11a | 802.11b} enable network
To save your settings, enter this command:
Step 11
save config
To see the configuration of a particular access point, enter this command:
Step 12
show ap config {802.11a | 802.11b} Cisco_AP
Information similar to the following appears:
Cisco AP Identifier.............................. 7
Cisco AP Name.................................... AP1
...
Tx Power
Num Of Supported Power Levels ................... 8
Phy OFDM parameters
802.11n Antennas
Cisco Wireless LAN Controller Configuration Guide
11-32
Refer to the hardware installation guide for your access point for the maximum transmit power
levels supported per regulatory domain. Also, refer to the data sheet for your access point for the
number of power levels supported.
Step 2
through
Step 7
for each access point radio for which you want to assign a static channel
Tx Power Level 1 .......................... 20 dBm
Tx Power Level 2 .......................... 17 dBm
Tx Power Level 3 .......................... 14 dBm
Tx Power Level 4 .......................... 11 dBm
Tx Power Level 5 .......................... 8 dBm
Tx Power Level 6 .......................... 5 dBm
Tx Power Level 7 .......................... 2 dBm
Tx Power Level 8 .......................... -1 dBm
Tx Power Configuration .................... CUSTOMIZED
Current Tx Power Level .................... 1
Configuration ............................. CUSTOMIZED
Current Channel ........................... 36
Extension Channel ......................... 40
Channel Width.............................. 40 Mhz
Allowed Channel List....................... 36,44,52,60,100,108,116,132,149,157
TI Threshold .............................. -50
Antenna Type............................... EXTERNAL_ANTENNA
External Antenna Gain (in .5 dBi units).... 7
Diversity.................................. DIVERSITY_ENABLED
Tx
A....................................... ENABLED
B....................................... ENABLED
Rx
A....................................... DISABLED
B....................................... DISABLED
C.................................... ENABLED
Chapter 11
Configuring Radio Resource ManagementWireless Device Access
OL-17037-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4400 series

Table of Contents