Using The Gui To Configure The Controller For Hybrid Reap - Cisco 2100 Series Configuration Manual

Chapter 13 Configuring Hybrid REAPWireless Device Access

Using the GUI to Configure the Controller for Hybrid REAP

The controller configuration for hybrid REAP consists of creating centrally switched and locally
switched WLANs. Follow the steps in this section to use the GUI to configure the controller for these
WLANs. This procedure uses these three WLANs as examples:
WLAN
employee
employee-local
guest-central
See the
Note
would prefer to configure the controller for hybrid REAP using the CLI.
Follow these steps to create a centrally switched WLAN. In our example, this is the first WLAN
Step 1
(employee).
a.
b.
Figure 13-2
c.
d.
e.
f.
g.
OL-17037-01
Security
WPA1+WPA2
WPA1+WPA2 (PSK) Local
Web authentication
"Using the CLI to Configure the Controller for Hybrid REAP" section on page 13-11
Click WLANs to open the WLANs page.
Choose Create New from the drop-down box and click Go to open the WLANs > New page (see
Figure 13-2).
WLANs > New Page
From the Type drop-down box, choose WLAN.
Enter a unique profile name for the WLAN in the Profile Name field.
Enter a name for the WLAN in the WLAN SSID field.
From the WLAN ID drop-down box, choose the ID number for this WLAN.
Click Apply to commit your changes. The WLANs > Edit page appears (see
Switching Interface Mapping (VLAN)
Central management (centrally switched
VLAN)
101 (locally switched VLAN)
Central management (centrally switched
VLAN)
Cisco Wireless LAN Controller Configuration Guide
Configuring Hybrid REAP
if you
Figure 13-3).
13-7