Cisco 2100 Series Configuration Manual page 594

Configuring RRM
monitor—Shows the Cisco radio monitoring.
•
Default 802.11a AP monitoring
profile {global | Cisco_AP}—Shows the access point performance profiles.
•
Default 802.11a AP performance profiles
• receiver—Shows the 802.11a or 802.11b/g receiver configuration and statistics.
802.11a Advanced Receiver Settings
Tx Pwr: Min,Max,Current Transmit Power for A.... 0,0,0
summary—Shows the configuration and statistics of the 802.11a or 802.11b/g access points
•
AP Name
----------------------------- ----------- ----------------
AP1250
txpower—Shows the transmit power assignment configuration and statistics.
•
Automatic Transmit Power Assignment
Cisco Wireless LAN Controller Configuration Guide
11-24
802.11a Monitor Mode........................... enable
802.11a Monitor Channels....................... Country channels
802.11a AP Coverage Interval................... 180 seconds
802.11a AP Load Interval....................... 60 seconds
802.11a AP Noise Interval...................... 180 seconds
802.11a AP Signal Strength Interval......... 60 seconds
802.11a Global Interference threshold.......... 10%
802.11a Global noise threshold................. -70 dBm
802.11a Global RF utilization threshold........ 80%
802.11a Global throughput threshold............ 1000000 bps
802.11a Global clients threshold............ 12 clients
RxStart : Signal Threshold..................... 15
RxStart : Signal Jump Threshold................ 5
RxStart : Preamble Power Threshold............. 2
RxRestart: Signal Jump Status................... Enabled
RxRestart: Signal Jump Threshold................ 10
TxStomp : Low RSSI Status...................... Enabled
TxStomp : Low RSSI Threshold................... 30
TxStomp : Wrong BSSID Status................... Enabled
TxStomp : Wrong BSSID Data Only Status......... Enabled
RxAbort : Raw Power Drop Status................ Disabled
RxAbort : Raw Power Drop Threshold............. 10
RxAbort : Low RSSI Status...................... Disabled
RxAbort : Low RSSI Threshold................... 0
RxAbort : Wrong BSSID Status................... Disabled
RxAbort : Wrong BSSID Data Only Status......... Disabled
--------------------------------------------....
pico-cell-V2 parameters in dbm units:...........
RxSensitivity: Min,Max,Current RxSense Thres.... 0,0,0
CCA Threshold: Min,Max,Current Clear Channel.... 0,0,0
--------------------------------------------....
Transmit Power Assignment Mode................. AUTO
Transmit Power Update Interval................. 600 seconds
Transmit Power Threshold....................... -65 dBm
Transmit Power Neighbor Count.................. 3 APs
Transmit Power Update Contribution............. SNI.
Transmit Power Assignment Leader............... 00:0b:85:43:dd:c0
Last Run....................................... 360 seconds ago
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
Channel TxPower Level
(36, 40) 1
OL-17037-01