Sample Wgb Configuration; Using The Gui To View The Status Of Workgroup Bridges - Cisco 2100 Series Configuration Manual

Chapter 7 Controlling Lightweight Access Points
•
•

Sample WGB Configuration

Here is a sample configuration of a WGB access point using static WEP with a 40-bit WEP key:
ap#configure terminal
Enter configuration commands, one per line.
ap(config)#dot11 ssid WGB_with_static_WEP
ap(config-ssid)#authentication open
ap(config-ssid)#guest-mode
ap(config-ssid)#exit
ap(config)#interface
ap(config)#station-role workgroup-bridge
ap(config-if)#encry mode wep 40
ap(config-if)#encry key 1 size 40 0 1234567890
ap(config-if)#WGB_with_static_WEP
ap(config-if)#end
To verify that the WGB is associated to an access point, enter this command on the WGB:
show dot11 association
Information similar to the following appears:
ap#show dot11 associations
802.11 Client Stations on Dot11Radio0:
SSID [FCVTESTING] :
MAC Address
000b.8581.6aee 10.11.12.1
ap#

Using the GUI to View the Status of Workgroup Bridges

Follow these steps to view the status of WGBs on your network using the controller GUI.
Click Monitor > Clients to open the Clients page (see
Step 1
OL-17037-01
These features are not supported for wired clients connected to a WGB:
MAC filtering
–
Link tests
–
Idle timeout
–
To enable the WGB to communicate with the lightweight access point, create a WLAN and make
sure that Aironet IE is enabled.
dot11Radio 0
IP address
End with CNTL/Z.
Device Name
WGB-client map1
Figure
Cisco Wireless LAN Controller Configuration Guide
Cisco Workgroup Bridges
Parent State
- Assoc
7-10).
7-37