Cisco 2100 Series Configuration Manual page 167

Chapter 4 Configuring Controller SettingsWireless Device Access
Version TLV: 0x0005—The software version of the controller, the access point, or the CDP
•
neighbor.
• Platform TLV: 0x0006—The hardware platform of the controller, the access point, or the CDP
neighbor.
These TLVs are supported only by the access point:
• Full/Half Duplex TLV: 0x000b—The full- or half-duplex mode of the Ethernet link on which CDP
packets are sent out. This TLV is not supported on access points that are connected directly to a 2100
series controller.
Power Consumption TLV: 0x0010—The maximum amount of power consumed by the access
•
point. This TLV is not supported on access points that are connected directly to a 2100 series
controller.
You can configure CDP and view CDP information using the GUI in controller software release 4.1 or
later or the CLI in controller software release 4.0 or later.
can use as a reference when performing the procedures in this section.
Changing the CDP configuration on the controller does not change the CDP configuration on the access
Note
points connected to the controller. You must enable and disable CDP separately for each access point.
Figure 4-27
OL-17037-01
Sample Network Illustrating CDP
Configuring Cisco Discovery Protocol
Figure 4-27 shows a sample network that you
Cisco Wireless LAN Controller Configuration Guide
4-71