Logging Out Of The Cli; Navigating The Cli; Enabling Wireless Connections To The Web-Browser And Cli Interfaces - Cisco 2100 Series Configuration Manual

Chapter 2 Using the Web-Browser and CLI Interfaces

Logging Out of the CLI

When you finish using the CLI, navigate to the root level and enter logout. The system prompts you to
save any changes you made to the volatile RAM.

Navigating the CLI

The CLI is organized around five levels:
Root Level
Level 2
Level 3
Level 4
Level 5
When you log into the CLI, you are at the root level. From the root level, you can enter any full command
without first navigating to the correct command level.
CLI and to perform common tasks.
Table 2-1
Command
help
?
command ?
exit
Ctrl-Z
save config
reset system
Enabling Wireless Connections to the Web-Browser and
CLI Interfaces
You can monitor and configure controllers using a wireless client. This feature is supported for all
management tasks except uploads from and downloads to the controller.
Before you can open the GUI or the CLI from a wireless client device, you must configure the controller
to allow the connection. Follow these steps to enable wireless connections to the GUI or CLI.
Step 1 Log into the CLI.
Step 2 Enter config network mgmt-via-wireless enable.
OL-17037-01
Commands for CLI Navigation and Common Tasks

Enabling Wireless Connections to the Web-Browser and CLI Interfaces

Table 2-1 lists commands you use to navigate the
Action
At the root level, view systemwide navigation
commands
View commands available at the current level
View parameters for a specific command
Move down one level
Return from any level to the root level
At the root level, save configuration changes from
active working RAM to non-volatile RAM
(NVRAM) so they are retained after reboot
At the root level, reset the controller without
logging out
Cisco Wireless LAN Controller Configuration Guide
2-9