Cisco 2100 Series Configuration Manual page 170

Configuring Cisco Discovery Protocol
Figure 4-30
This page shows the following information:
The controller port on which the CDP packets were received
•
The name of each CDP neighbor
•
The IP address of each CDP neighbor
•
The port used by each CDP neighbor for transmitting CDP packets
•
The time left (in seconds) before each CDP neighbor entry expires
•
The functional capability of each CDP neighbor, defined as follows: R - Router, T - Trans Bridge,
•
B - Source Route Bridge, S - Switch, H - Host, I - IGMP, r - Repeater, or M - Remotely Managed
Device
The hardware platform of each CDP neighbor device
•
To see more detailed information about each interface's CDP neighbor, click the name of the desired
Step 2
interface neighbor. The CDP > Interface Neighbors > Detail page appears (see
Figure 4-31
Cisco Wireless LAN Controller Configuration Guide
4-74
CDP > Interface Neighbors Page
CDP > Interface Neighbors > Detail Page
Chapter 4 Configuring Controller SettingsWireless Device Access
Figure 4-31).
OL-17037-01