Using The Cli To View The Status Of Workgroup Bridges; Using The Cli To Debug Wgb Issues - Cisco 2100 Series Configuration Manual

Cisco Workgroup Bridges

Using the CLI to View the Status of Workgroup Bridges

Follow these steps to view the status of WGBs on your network using the controller CLI.
To see any WGBs on your network, enter this command:
Step 1
show wgb summary
Information similar to the following appears:
Number of WGBs................................... 1
MAC Address
----------------- ----------
00:0d:ed:dd:25:82
To see the details of any wired clients that are connected to a particular WGB, enter this command:
Step 2
show wgb detail wgb_mac_address
Information similar to the following appears:
Number of wired client(s): 1
MAC Address
------------------- ---------- -------- ---------
00:0d:60:fc:d5:0b

Using the CLI to Debug WGB Issues

Use the commands in this section if you experience any problems with the WGB.
1.
2.
3.
4.
Cisco Wireless LAN Controller Configuration Guide
7-40
IP Address AP Name
10.24.8.73
IP Address AP Name
10.24.8.75
To enable debugging for IAPP messages, errors, and packets, enter these commands:
debug iapp all enable—Enables debugging for IAPP messages.
•
debug iapp error enable—Enables debugging for IAPP error events.
•
debug iapp packet enable—Enables debugging for IAPP packets.
•
If you experience a roaming issue, enter this command:
debug mobility handoff enable
If you experience an IP assignment issue and DHCP is used, enter these commands:
debug dhcp message enable
•
• debug dhcp packet enable
If you experience an IP assignment issue and static IP is used, enter these commands:
• debug dot11 mobile enable
• debug dot11 state enable
Status WLAN
-------- ------ ----
a1 Assoc 3
Mobility WLAN
----- -----
a1 Local 3
Chapter 7 Controlling Lightweight Access Points
Auth Protocol Clients
----- --------- --------
Yes 802.11b 1
Auth
Yes
OL-17037-01