Using The Gui To Configure Aggressive Load Balancing; Using The Cli To Configure Aggressive Load Balancing - Cisco 2100 Series Configuration Manual

Configuring Aggressive Load Balancing
When you use Cisco 7921 and 7920 Wireless IP Phones with controllers, make sure that aggressive load
Note
balancing is disabled for each controller. Otherwise, the initial roam attempt by the phone may fail,
causing a disruption in the audio path.

Using the GUI to Configure Aggressive Load Balancing

Follow these steps to configure aggressive load balancing using the GUI.
Click Controller > General to open the General page.
Step 1
From the Aggressive Load Balancing drop-down box, choose either Enabled or Disabled to configure
Step 2
this feature.
Step 3 Click Apply to commit your changes.
Click Save Configuration to save your changes.
Step 4

Using the CLI to Configure Aggressive Load Balancing

Follow these steps to configure aggressive load balancing using the CLI.
To enable or disable aggressive load balancing, enter this command:
Step 1
config load-balancing status {enable | disable}
Step 2 To set the client count for aggressive load balancing, enter this command:
config load-balancing window clients
You can enter a value between 0 and 20 for the clients parameter.
To save your changes, enter this command:
Step 3
save config
To verify your settings, enter this command:
Step 4
show load-balancing
Information similar to the following appears:
Aggressive Load Balancing........................ Enabled
Aggressive Load Balancing Window.............. 5 clients
Cisco Wireless LAN Controller Configuration Guide
4-30
Chapter 4 Configuring Controller SettingsWireless Device Access
OL-17037-01