Using The Cli To Configure Mobility Groups - Cisco 2100 Series Configuration Manual

Configuring Mobility Groups
On the Mobility Multicast Messaging page, check the Enable Multicast Messaging check box to enable
Step 6
the controller to use multicast mode to send Mobile Announce messages to the mobility members. If you
leave it unchecked, the controller uses unicast mode to send the Mobile Announce messages. The default
value is unchecked.
If you enabled multicast messaging in the previous step, enter the multicast group IP address for the local
Step 7
mobility group in the Local Group Multicast IP Address field. This address is used for multicast mobility
messaging.
Note
Click Apply to commit your changes.
Step 8
If desired, you can also configure the multicast group IP address for non-local groups within the mobility
Step 9
list. To do so, click the name of a non-local mobility group to open the Mobility Multicast Messaging >
Edit page (see
in the Multicast IP Address field.
Note
Figure 12-12
Step 10 Click Apply to commit your changes.
Step 11 Click Save Configuration to save your changes.

Using the CLI to Configure Mobility Groups

Follow these steps to configure mobility groups using the CLI.
The config mobility secure-mode {enable | disable} command is not supported in controller software
Note
release 5.2 even if it is present in the controller CLI.
To check the current mobility settings, enter this command:
Step 1
show mobility summary
Cisco Wireless LAN Controller Configuration Guide
12-14
In order to use multicast messaging, you must configure the IP address for the local mobility
group.
Figure 12-12), and enter the multicast group IP address for the non-local mobility group
If you do not configure the multicast IP address for non-local groups, the controller uses unicast
mode to send mobility messages to those members.
Mobility Multicast Messaging > Edit Page
Chapter 12 Configuring Mobility GroupsWireless Device Access
OL-17037-01