Regulatory Information For Lightweight Access Points; Manufacturers Federal Communication Commission Declaration Of Conformity Statement; A P P E N D I X B Declarations Of Conformity And Regulatory Information - Cisco 2100 Series Configuration Manual

Regulatory Information for Lightweight Access Points

Regulatory Information for Lightweight Access Points
This section contains regulatory information for lightweight access points. The information is in these
sections:
•
•
•
•
•
•
•
Manufacturers Federal Communication Commission Declaration of Conformity
Statement
FOR HOME OR OFFICE USE
Model:
FCC Certification number:
Manufacturer:
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1.
2.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
Cisco Wireless LAN Controller Configuration Guide
B-2
Manufacturers Federal Communication Commission Declaration of Conformity Statement, page
B-2
Department of Communications—Canada, page B-3
European Community, Switzerland, Norway, Iceland, and Liechtenstein, page B-4
Declaration of Conformity for RF Exposure, page B-5
Guidelines for Operating Controllers and Access Points in Japan, page B-7
Administrative Rules for Cisco Aironet Access Points in Taiwan, page B-8
Declaration of Conformity Statements, page B-10
Tested To Comply
With FCC Standards
AIR-AP1010-A-K9, AIR-AP1020-A-K9, AIR-AP1030-A-K9
LDK102057
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
Appendix B Declarations of Conformity and Regulatory Information
OL-17037-01