Power Up And Initial Configuration; Checking Conditions Prior To System Startup - Cisco Catalyst 9800-80 Installation Manual

Power Up and Initial Configuration

This chapter guides you through a basic controller configuration, which is sufficient for you to access your
network. Complex configuration procedures are beyond the scope of this publication and can be found in the
modular configuration and command reference publications in the Cisco IOS software configuration
documentation set that corresponds to the software release installed on your Cisco hardware.
•
•
•
•
•
•
•

Checking Conditions Prior to System Startup

Ensure that all the card slots and compartments are closed. Install blank faceplates on empty slots. Always
have power supply slots filled. If you leave a power supply slot uncovered, then you risk exposure to hazardous
voltages on the power pins on the midplane.
Warning Statement 1029—Blank Faceplates and Cover Panels.
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all
cards, faceplates, front covers, and rear covers are in place.
Note To view the boot sequence, you must have a console connection to the Cisco Catalyst 9800-80 Wireless
Controller before it powers up.
Ensure that the following conditions are addressed before starting up the controller:
• The network interface cable or the optional Management port cable is connected.
Checking Conditions Prior to System Startup, on page 53
Powering Up the Controller, on page 54
Performing the Initial Configuration on the Controller, on page 57
Saving Your Controller Configuration, on page 65
Verifying the Initial Configuration, on page 66
Powering Off the Controller Safely, on page 66
Environmental Monitoring and Reporting Functions, on page 67
C H A P T E R
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
5
53