Configuring The Static Lsp And Pw On The Cx600 - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config)#cesop jitter-buffer 1 2000
huawei(config)#cesop encap 0 ssrc rcv 0 tx 0
----End

14.4.7.5 Configuring the Static LSP and PW on the CX600

Data Plan
Item
Parameters of the GE
sub interface
E1 port parameters
Static LSP parameters
Static PW parameters
NOTE
The PW parameters on
the CX600 must be the
same as those on the
ONU.
Procedure
Step 1 Configure the GE sub interface.
Set the ID of the sub interface to 1/0/0.1, add the sub interface to VLAN 300, and set the IP
address of the sub interface to 10.0.0.20/24.
[CX600]interface GigabitEthernet 1/0/0.1
[CX600-GigabitEthernet1/0/0.1]vlan-type dot1q 300
[CX600-GigabitEthernet1/0/0.1]ip address 10.0.0.20 24
[CX600-GigabitEthernet1/0/0.1]quit
Enable MPLS globally and then enable MPLS for the GE sub interface.
Issue 01 (2014-04-30)
Data
Sub interface ID: 1/0/0.1
VLAN to which the sub interface belongs: 300
IP address of the sub interface: 10.0.0.20/24
Port ID: 2/1/0
Working mode: channelized mode (CEL)
Timeslot: 1-15
Parameters configured on the ingress node:
l Destination ID address: 10.0.0.10/32
l Next-hop IP address: 10.0.0.10
l Egress interface: GE sub interface 1/0/0.1
l Egress label: 8200 (the same as the Rx LSP label on the ONU)
Parameters configured on the egress node:
l Ingress interface: GE sub interface 1/0/0.1
l Ingress label: 2000 (the same as the Tx LSP label on the ONU)
Tx PW label: 8500 (the same as the Rx PW label on the ONU)
Rx PW label: 8000 (the same as the Tx PW label on the ONU)
RTP header: enabled
Number of TDM frames encapsulated in each PW packet: 8
Maximum jitter delay: 2 ms
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 FTTM Configuration (Base Station Access)
//The maximum jitter delay is 2 ms.
//Both the Tx and Rx SSRIDs are 0.
1492