Callhome-3; Cdp Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
alert:[chars] exceeds maximum limit for destination profile:[chars].
CALLHOME-6
Error Message CALLHOME-6-NONCRIT_EVENT: [chars].

CDP Messages

This section contains the Cisco Discovery Protocol (CDP) messages.
CDP-2
Error Message
CDP-3
Error Message
OL-15956-01
CALLHOME-3-MESSAGE_SIZE_EXCEED: message size for callhome
The message size for the Call Home alert exceeds the maximum limit for the destination
Explanation
profile shown in the error message.
Recommended Action Verify the maximum message size for the destination profile under question.
Increase it, if possible, to match the maximum limit allowed by your e-mail destinations.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
A noncritical Call Home event occurred.
Explanation
If you have configured your e-mail address to receive Call Home notifications,
Recommended Action
check your e-mail for more details about this Call Home event. If Call Home was not enabled, use
either CLI commands or Fabric Manager procedures to get more information about the error.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
CDP-2-INITFAIL: CDP Daemon Initialization failed: [chars].
The Cisco Discovery Protocol daemon initialization failed because of the reason shown
Explanation
in the error message.
Recommended Action No action is required.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
CDP-3-ALLOCFAIL: Heap Memory allocation failed: [chars].
The Cisco Discovery Protocol daemon is out of dynamic memory. The error message
Explanation
shows the context where the failure occurred.
Recommended Action No action is required.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-21