Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 359

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
) Timeout due to excessive processing time [chars].
Error Message
SS_EID_VL_ER_LOCAL_PORT_EXCLUDED ) Local FC port excluded [chars].
Error Message
Login excluded [chars].
Error Message
SS_EID_VL_ER_LUN_RESOURCE_RAN_OUT ) Too many LUNs were presented to a node
[chars].
OL-15956-01
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_IO_TIMEOUT_OVERALL
A managed disk has timed out. This error has been reported because a large number of
Explanation
disk timeout conditions have been detected. The problem is probably caused by a failure of some
other component on the SAN.
1. Repair problems on all disk controllers and switches on the same SAN as
Recommended Action
this cluster. 2. If problems are found, mark this error as fixed. 3. If no switch or disk controller
failures can be found, take an error log dump and call your customer support representative.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
Explanation A local Fibre Channel port has been excluded.
1. Repair the Fibre Channel network fabric. 2. Check the status of the disk
Recommended Action
controller. If all disk controllers show good status, mark the error you have just repaired fixed. 3. If
the error persists and no other cause can be determined, replace the Caching Services Module.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_LOGIN_EXCLUDED )
Login has been excluded.
Explanation
1. In the sequence shown, exchange the field-replaceable units (FRUs) for new
Recommended Action
FRUs: Fibre Channel cable, switch to remote port. 2. Start a cluster discovery operation to recover
the login. 3. Check the status of the disk controller. If all disk controllers show a good status, mark
the error you have just repaired fixed. 4. If the error persists and no other cause can be determined,
replace the Caching Services Module.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
Explanation The configuration is not valid. Too many devices have been presented to the cluster or
node.
1. Remove unwanted devices from the Fibre Channel network fabric. 2. Start
Recommended Action
a cluster discovery operation to find devices. 3. List all connected managed disks. Check that the
configuration is as expected. Mark the error you have just repaired fixed.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-323