Epp-5; Ethport Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
switch.

ETHPORT Messages

This section contains the Ethernet port (ETHPORT) messages.
ETHPORT-3
Error Message
[chars] is not supported.
ETHPORT-5
Error Message
(Administratively down).
Error Message
change).
OL-15956-01
EPP-5-EPP_LOOPBACK: Interface [chars] is looped back to the same
The interface is looped back to another interface on the same switch.
Explanation
Check the connectivity of this interface and ensure that it is connected to
Recommended Action
another switch.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER: Transceiver for interface
Explanation The transceiver is not from an authorized vendor.
Enter the show flash command or use a similar Fabric Manager/Device
Recommended Action
Manager procedure to determine which transceiver is being used. Contact customer support for a list
of authorized transceiver vendors.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
ETHPORT-5-IF_DOWN_ADMIN_DOWN: Interface [chars] is down
The interface has been configured to be administratively down.
Explanation
Enter the show flash command or use a similar Fabric Manager/Device
Recommended Action
Manager procedure to set this interface to administratively up.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
ETHPORT-5-IF_DOWN_CFG_CHANGE: Interface [chars] is down(Config
Explanation FCIP interface temporarily down because of a reconfiguration.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-51