Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 357

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
) Media errors on back-end Managed Disk [chars].
Error Message
SS_EID_VL_ER_BASE_EVENT_RESOURCE_RAN_OUT ) Software error [chars].
Error Message
SS_EID_VL_ER_CONTROLLER_CONFIG_INVALID ) Incorrect controller configuration
[chars].
Error Message
SS_EID_VL_ER_DEVICE_PORT_LOGIN_LOSS ) Number of controller logins reduced
[chars].
OL-15956-01
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VG_ER_MED_ERRS_TOO_HIGH
Media errors on backend managed disk.
Explanation
1. Repair the enclosure or disk controller. 2. Add the managed disk into the
Recommended Action
cluster. 3. Check the managed disk status. If all managed disks show a status of online, mark the
error you have just repaired as fixed.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
The error that is logged in the cluster error log indicates a software problem in the
Explanation
cluster.
1. Ensure that the software is at the latest level on the cluster. 2. Run a
Recommended Action
configuration dump and a logged data dump. Save the dump data. 3. Ask your customer support
representative for assistance. 4. Mark the error you have just repaired as fixed.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
Incorrect disk controller configuration.
Explanation
1. Using service documentation for the disk controller, check that the correct
Recommended Action
configuration is set up for the disk controller. See also the IBM TotalStorage SAN Volume Controller
for Cisco MDS 9000: Configuration Guide. 2. Mark the error you have just repaired as fixed.3. Start
a cluster discovery operation.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
Explanation The number of controller logins has been reduced. One possible cause is that the user
intentionally reconfigured the system.
1. Check whether the controller has regained connectivity. If it has not, check
Recommended Action
the cable connection to the remote-device port. 2. If all logins to a remote-device port have failed
and you cannot solve the problem by changing cables, check the condition of the remote-device port
and the condition of the remote device. 3. Start a cluster discovery operation. 4. Check the status of
the disk controller. If all disk controllers show a good status, mark the error you have just repaired
as fixed.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-321