Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 414
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
during boot (error-id [hex]).
Error Message
start) failed with return value: ([dec]).
Error Message
Error Message
standby causing standby to reset.
Error Message
restart system on standby.
Cisco MDS 9000 Family System Messages Reference
2-378
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
SYSMGR-2-STARTUP_CONVERSION_FAILED: Startup config conversion failed
The conversion of the startup configuration failed during boot.
Explanation
If the problem persists, Use the init system CLI command from the
Recommended Action
switch(boot)# prompt to initialize the configuration partition. Note:This is a disruptive command.
This command will initialize the switch, reset the entire internal disk, and reformat the bootflash:
partition.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SYSMGR-2-START_SCRIPT_FAILED: Start script (/isan/etc/rc.sysmgr
The initialization of the system could not complete.
Explanation
Recommended Action
If you purchased Cisco support through a Cisco reseller, contact the reseller
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-2-SWITCHOVER_OVER: Switchover completed.
The switchover is completed.
Explanation
No action is required.
Recommended Action
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
SYSMGR-2-SYNC_FAILURE_STANDBY_RESET: Failure in syncing messages to
Resetting the standby because messaging and transaction service (MTS) on the active is
Explanation
unable to synchronize messages to the standby.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-2-UNEXPECTED_GSYNC_RESTART_STANDBY: Sending a message to
Explanation
Activity occurred on the active supervisor that is incompatible with the state of standby.
System will be restarted on standby.
Recommended Action
No action is required.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01
Advertisement
Table of Contents
