Scsi Target Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
SCSI target Messages
This section contains the SCSI target (SCSI target) messages.
SCSI target-2
Error Message SCSI target-2-PROC_ADD_NPORT_FAIL: Failed to set local nport with SCSI
target driver error: [hex].
Error Message
SCSI target driver error: [hex].
Error Message
target driver error: [hex].
Error Message
pwwn from WWN Manager error: [hex] response: [hex].
Cisco MDS 9000 Family System Messages Reference
2-296
SCSI target process added an N port with its peer kernel driver listed. No SCSI
Explanation
discovery can be performed.
Recommended Action
Enter the show SCSI target internal driver CLI command or use a similar
Fabric Manager/Device Manager procedure to collect more information.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
SCSI target-2-PROC_OPEN_VHBA_DEVICE_FAIL: Failed to communicate with
SCSI target process failed to communicate with its peer kernel driver listed in the error
Explanation
message. No SCSI discovery can be performed.
Enter the show SCSI target internal driver command or use a similar Fabric
Recommended Action
Manager/Device Manager procedure to collect more information.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
SCSI target-2-PROC_SET_SCSI_INDEX_FAIL: Failed to set SCSI index SCSI
SCSI target process failed to set SCSI index with its peer kernel driver. No SCSI
Explanation
discovery can be performed.
Enter the show SCSI target internal driver command or use a similar Fabric
Recommended Action
Manager/Device Manager procedure to collect more information.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
SCSI target-2-PROC_WWNM_GET_WWN_FAIL: Failed to get local controller
Explanation
SCSI target process used the wwnm_bwt_get_local_controller_wwn() API for the
port WWN and it failed because of the error and response code listed. No SCSI discovery can be
performed.
Recommended Action
Enter the show process cpu and show system internal sysmgr service all
commands or use a similar Fabric Manager/Device Manager procedure to collect further
information. See WWN Manager system error codes for the reason.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01
Advertisement
Table of Contents
