Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 239
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message MODULE-5-MOD_STARTUP_CFG_MISMATCH: The startup configuration cannot be
applied to a different module type for module [dec] (serial: [chars]). [chars]
module is replacing [chars].
Error Message
[dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]).
Error Message
Error Message MODULE-5-XBAR_OK: Xbar [dec] is online (serial: [chars]).
Error Message MODULE-5-XBAR_REINIT: Re-initializing xbar [dec] (serial: [chars]).
OL-15956-01
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
Cisco MDS SAN-OS Release 2.0(1b).
Deprecated
The startup configuration for the module contains information about a different type of
Explanation
module instead of containing information about the current one.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
MODULE-5-MOD_WARNING: Module [dec] reported warnings on ports
Module [dec] reported a warning in the runtime diagnostic because the failure of some
Explanation
of the ports.
Collect module information by entering the show module internal all module
Recommended Action
[dec] command or by using a similar Fabric Manager procedure.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS SAN-OS Release 2.0(1b).
Deprecated
MODULE-5-STANDBY_SUP_OK: Supervisor [dec] is standby.
Module is ready to be configured and to switch traffic.
Explanation
No action is required.
Recommended Action
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
Xbar is ready to be configured and to switch traffic.
Explanation
Recommended Action
No action is required.
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Xbar reported a failure during the initialization phase and will be rebooted.
Explanation
Collect information about the module by issuing the show module internal
Recommended Action
all xbar <modulenumber> CLI command or by using a similar Fabric Manager procedure.
Introduced
Cisco MDS SAN-OS Release 3.0(1).
Cisco MDS 9000 Family System Messages Reference
2-203
Advertisement
Table of Contents
