Svc-0; Svc-1; Svc-2 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Reason: [hex].
Error Message
user for interface [chars].
Error Message SVC-2-SVC_SYSLOG_PATH_FAILURE: System Health detected SVC packet path
failure for [chars].
Error Message
failure for [chars].
Cisco MDS 9000 Family System Messages Reference
2-316
SVC-2-SVC_SYSLOG_INIT_FAILED: Initialization failed for SVC: [chars],
Initialization failed for the SAN Volume Controller (SVC).
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(4a).
Introduced
SVC-2-SVC_SYSLOG_NO_PORT_CHAN: Too many PortChannels allocated by
The SAN Volume Controller (SVC) interface needs PortChannels to operate. Too many
Explanation
PortChannels have been allocated by the user for the interface to operate correctly.
Delete unneeded user configured PortChannels and shut down the SVC
Recommended Action
interface. Then bring the SVC interface back up.
Cisco MDS SAN-OS Release 1.3(4a).
Introduced
Explanation
The Caching Services Module (CSM) has been brought down by the System Health
monitor. System health has detected a failure in the packet path between the SAN Volume Controller
(SVC) interface on the CSM and the backplane. This system health test is run periodically.
Recommended Action
Enter the no shutdown command or use a similar Fabric Manager/Device
Manager procedure on the SVC interface to bring the node back online. If a subsequent packet path
failure occurs, replace the CSM module.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
SVC-2-SVC_SYSLOG_PORT_FAILURE: System Health indicated port loopback
Explanation
The SAN Volume Controller (SVC) interface has been brought down because of a port
loopback failure.
Bring the port back up using either the CLI or Cisco Fabric Manager/Device
Recommended Action
Manager. Using the CLI, enter the no shutdown command on the SVC interface to bring the port
back up. If a subsequent port loopback failure occurs, replace the SVC module.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01
Advertisement
Table of Contents
