Bootvar-5 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
verify file [chars], error = [hex].
Error Message
Error Message
autosync.
Error Message
completion.
Error Message BOOTVAR-5-IMAGE_NOTEXISTS: Warning: image [chars] doesn't exist on
sup[dec].
Error Message
supervisor, starting...
Cisco MDS 9000 Family System Messages Reference
2-18
BOOTVAR-5-AUTOCOPY_VERIFY_SEND_FAILED: Unable to ask standby to
After copying the image to the standby supervisor, the active supervisor failed to verify
Explanation
the integrity of that image on the standby supervisor.
Recommended Action
Turn auto-copy off and back on.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
BOOTVAR-5-AUTOSYNC_DONE: Image autosync done.
The image synchronization was done successfully.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
BOOTVAR-5-AUTOSYNC_REBOOT: Rebooting standby after successful
Image automatic synchronization was successful. The system is resetting the standby
Explanation
supervisor to load the new image.
Verify that the standby supervisor reloads correctly.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
BOOTVAR-5-AUTOSYNC_START: Starting image autosync. Please wait until
The standby supervisor has requested a synchronization of the current image.
Explanation
Recommended Action
No action is required.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
The input image name does not exist on the specified supervisor.
Explanation
Check whether the input image name you entered exists and make sure that
Recommended Action
you have the image on the flash before reboot.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
BOOTVAR-5-NEIGHBOR_UPDATE_AUTOCOPY: auto-copy supported by opposing
Explanation
The standby supervisor supports automatic copy. Automatic copy has started.
No action is required.
Recommended Action
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01
Advertisement
Table of Contents
