Vrrp_Eng-2 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
[chars]. Invalid IP configuration. Reason: [chars].
Error Message VRRP_ENG-2-VR_FAILURE: Error in VR[chars] [dec] interface [chars].
Going to init state.
VRRP_ENG-3
Error Message
VRRP_ENG-4
Error Message VRRP_ENG-4-BAD_ADV: VR[chars] ID [dec] on interface [chars] bad
advertisement received:
Cisco MDS 9000 Family System Messages Reference
2-444
VRRP_ENG-2-INVALID_CONFIG: Cannot start the VR [dec] on the interface
The specified virtual router on the interface is enabled, but the IP configuration is not
Explanation
valid because of the error shown in the error message.
Recommended Action
Enter the show interface CLI command or use a similar Fabric
Manager/Device Manager procedure to ensure the IP address of the interface is configured and is in
the same subnet of the virtual router address.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation
The virtual router on the interface is in the initialization state because of an internal
error.
Enter the show interface CLI command or use a similar Fabric
Recommended Action
Manager/Device Manager procedure to check the status of the interface. Check the configuration,
status, and statistics of the specified virtual router and enable VRRP debug for further information.
Enter shutdown and no shutdown on the specified virtual router.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
VRRP_ENG-3-INIT_FAILED: Initialization failed. Component [chars].
Explanation
The service failed to start. The failure occurred while initializing the component shown
in the error message.
Recommended Action
Enter the show process CLI command or use a similar Fabric Manager/Device
Manager procedure to check the status of the other processes and debug the specified component.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
The virtual router specified has received an invalid advertisement.
Explanation
Check that all VRRP nodes have the same configuration.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
reason [chars].
OL-15956-01
Advertisement
Table of Contents
