Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 415

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message SYSMGR-2-VOLATILE_DB_FULL: System volatile database usage is
unexpectedly high at [dec]%
Error Message
Error Message SYSMGR-2-WDT_KGDB: System watchdog kgdb has been [chars] for slot
[dec].
SYSMGR-3
Error Message
due to configuration change.
Error Message SYSMGR-3-CFGERASE_FAILED: Configuration erase failed (error-id [hex]).
OL-15956-01
System volatile database space is almost full.
Explanation
Issue the
Recommended Action
your technical support representative.
Introduced Cisco MDS SAN-OS Release 3.0(1).
SYSMGR-2-WARMSWITCHOVER_START: This supervisor is becoming active.
A cold switchover has started.
Explanation
When the other supervisor is back online, enter the show system reset-reason
Recommended Action
CLI command or use a similar Fabric Manager/Device Manager procedure to find out what caused
the switchover.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
System watchdog kgdb has been [chars]. If the command has been enabled, the system
Explanation
will go into kgdb if there is a watchdog timeout.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.2(1).
Introduced
SYSMGR-3-CAPABILITY_REDUN_CHANGE: Redundancy mode changed to [chars]
Some configuration changes have occurred causing the administrative redundancy
Explanation
mode to change.
No action is required.
Recommended Action
Introduced Cisco MDS SAN-OS Release 1.2(2a).
The requested configuration erase has failed. The error message shows the error ID
Explanation
representing the failure reason.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
CLI command. If this message continues, contact
system pss shrink
Cisco MDS 9000 Family System Messages Reference
2-379