Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 364

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
error [chars].
Error Message
to form a cluster due to lack of cluster resources [chars].
Error Message
is unable to see the FC fabric [chars].
Error Message
domain error [chars].
Error Message
Node repeatedly crashing due to a software fault [chars].
Cisco MDS 9000 Family System Messages Reference
2-328
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_MEM_SIZE ) Memory size
The detected memory size does not match the expected memory size for the cluster.
Explanation
A memory module on the Caching Services Module is probably faulty. Reload
Recommended Action
the node. If the error persists, replace the Caching Services Module.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_MISSING_RES ) Unable
The node is unable to locate sufficient other nodes in the cluster or the quorum disk
Explanation
controller needed in order to form a cluster.
Check the status of the quorum disk controller and the other nodes in the
Recommended Action
cluster. If the quorum disk has failed, perform the problem determination procedures for the disk
controller. Otherwise perform problem determination on the missing nodes and network.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_NO_FABRIC ) The node
No active or functioning logical Fibre Channel port was detected by the software.
Explanation
Recommended Action Reload the node. If the problem persists, replace the Caching Services Module.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_PWR_DMN_ERR ) Power
The two nodes in an I/O group are on the same Caching Services Module.
Explanation
Determine if both nodes on the Caching Services Module are in fact in the
Recommended Action
same I/O group. If so, determine what the configuration should be. Remove one of the nodes and
add a node to the I/O group which is not on the same Caching Services Module. If both nodes are
not in the same I/O group, ask your customer support representative for assistance.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_NODERR_REPEATED_ASSERTS )
The number of software faults has exceeded the maximum allowed for the time period.
Explanation
Recommended Action 1. Delete the node from the cluster. 2. Add the node back into the cluster. 3.
Ensure that the software is at the latest level on the cluster. If not, upgrade the cluster with the latest
level of code. 4. If the error continues, ask your customer support representative for assistance.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01