Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 397

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
permitted range for battery conditioning (5C-40C).
Error Message
battery [dec] ([hex]).
SVC_BATTERY-SLOT#-4
Error Message
the required threshold.
SVC_BATTERY-SLOT#-6
Error Message
the required threshold.
Error Message SVC_BATTERY-SLOT#-6-CONDITIONING_CANCELLED: Temperature outside
permitted range for battery conditioning (5C-40C). Battery [dec] conditioning
cancelled.
OL-15956-01
SVC_BATTERY-SLOT#-2-CONDITIONING_DISABLED: Temperature outside
The temperature of the line card is not within the range to permit battery conditioning.
Explanation
Make sure the temperature of the line card is between 5 and 40
Recommended Action
SVC_BATTERY-SLOT#-2-DISCHARGING_FAILURE: Discharging failure in
The module encountered failures while discharging a battery.
Explanation
Replace the battery. If you purchased Cisco support through a Cisco reseller,
Recommended Action
contact the reseller directly. If you purchased support directly from Cisco Systems, contact Cisco
Technical Support.
Cisco MDS SAN-OS Release 1.3(4a).
Introduced
SVC_BATTERY-SLOT#-4-BATTERY_CAPACITY_LOW: Battery capacity is below
Explanation The battery is lower than the required threshold.
Make sure the temperature is within the range to allow charging.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC_BATTERY-SLOT#-6-BATTERY_CAPACITY_OK: Battery capacity is above
The battery is above the required threshold.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
The temperature of the module is not within the range to permit battery conditioning.
Explanation
Make sure the temperature of the line card is between 5 and 40
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Cisco MDS 9000 Family System Messages Reference
0
C.
0
C.
2-361