Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 205

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices.
Error Message
FCID [chars] may not be able to participate in Inter-VSAN zone since domain [dec]
is disallowed in the interop mode for VSAN [dec].
Error Message
[chars] may not be able to participate in Inter-VSAN zone since domain [dec] is
already assigned in VSAN [dec].
Error Message
Domain [chars].
OL-15956-01
IVR-2-DEVICE_VSAN_REWRITE_FAILURE: Failure while programming VSAN
Explanation Device failed to program the VSAN rewrite entries, probably because the hardware ran
out of VSAN rewrite entries. This can happen if there are too many devices in an inter-VSAN zone
or too many local VSANs in the VSAN topology.
Reduce the number of domains involved in IVR by moving the members of the
Recommended Action
active IVR zone set to fewer switches. Also, reduce the number of redundant transit VSANs, if any.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
IVR-2-DOMAIN_DISALLOWED_IN_INTEROP: Device with port WWN [chars] and
VSAN interop modes place restrictions on what domain ranges are allowed. This
Explanation
domain is out of the range allowed for this interop mode. Refer to the Cisco MDS 9000 Family CLI
Configuration Guide or Cisco MDS 9000 Family Fabric Manager Configuration Guide for details
on the domain range limitations.
Change the domain of the switch to which this IVR zone member is connected
Recommended Action
so that it is within the allowed domain list for the interop mode. The domain identifier can be
statically assigned using the fcdomain interface. You can also configure a range of domains allowed
in a VSAN using the fcdomain's allowed-domains interface.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
IVR-2-DOMAIN_UNAVAILABLE: Device with port WWN [chars] and FCID
Device with the port WWN and FC ID shown in the error message may not be able to
Explanation
participate in the inter-VSAN zone because the domain shown is already assigned in a VSAN.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
IVR-2-INTEROP_MODE_2_OR_3_BF_FAILED: [chars] VSAN [dec] Virtual
Build fabric failed in VSAN [dec]. The build fabric was initiated to remove an unused
Explanation
virtual domain from the fcdomain list in that VSAN. The virtual domain still remains in the
fcdomain list and hence it would not be available in that VSAN for assignment.
Perform a manual build fabric using fcdomain's interface if you would like to
Recommended Action
remove the unused virtual domain(s) from the fcdomain list.
Introduced Cisco MDS SAN-OS Release 1.3(4a).
Cisco MDS 9000 Family System Messages Reference
2-169