Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 435

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message SYSTEMHEALTH-2-OHMS_LC_CF_INIT_ERRORS: Compact Flash firmware CRC
checksum procedure encountered an error during initialization on module [dec]
Reason: [chars].
Error Message SYSTEMHEALTH-2-OHMS_MOD_PORT_LB_TEST_FAILED: Module [dec] Port [dec]
has failed loop back tests.
Error Message SYSTEMHEALTH-2-OHMS_NVRAM_FAILED: Nvram test maximum failures reached
for module [dec] for blocks 0x%llx.
Error Message
requested due to errors found by [chars] test.
Error Message
snake loopback tests.
Error Message SYSTEMHEALTH-2-OHMS_SUP_CF_CRC_FAILED: Compact Flash firmware CRC
checksum on module[dec] is corrupted.
OL-15956-01
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.3(1a).
Introduced
Port loop-back test failure.
Explanation
Recommended Action No action is required.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Explanation NVRAM failed.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
SYSTEMHEALTH-2-OHMS_MOD_RELOAD_REQ: Module [dec] reload being
System Health module reload request.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SYSTEMHEALTH-2-OHMS_MOD_SNAKE_TEST_FAILED: Module [dec] has failed
Explanation Snake test failure.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Compact Flash firmware corrupted.
Explanation
Replace the compact flash on this module.
Recommended Action
Cisco MDS SAN-OS Release 3.1(3).
Introduced
Compact Flash CRC checksum initializations failed.
Cisco MDS 9000 Family System Messages Reference
2-399