Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 402

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
service "[chars]".
Error Message
failed.
Error Message
configuration.
Error Message
failed with return value: ([dec]).
Error Message SYSMGR-2-DELETE_BINARY_STARTUP_FAILED:
config failed during boot (error-id [hex]).
Cisco MDS 9000 Family System Messages Reference
2-366
SYSMGR-2-CONVERT_LIB_NOTFOUND: Conversion library not found for
The system could not find the conversion library for this service.
Explanation
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
SYSMGR-2-CONVERT_STARTUP_ABORTED: Conversion of startup-config
The conversion of the startup configuration was terminated.
Explanation
If the problem persists, issue the init system CLI command from the
Recommended Action
switch(boot)# prompt to initialize the configuration partition. Note: This is a disruptive command.
This command will initialize the switch, reset the entire internal disk, and reformat the bootflash:
partition.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-2-CONVERT_ZIPPING_FAILED: Failed to zip the converted startup
Conversion of the startup configuration failed when system was trying to zip the
Explanation
converted configuration.
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-2-CREATE_DONEFILE_FAILED: Creating /var/run/sysmgr.initdone
Explanation The initialization of the system could not complete.
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
T deletion of the binary startup configuration failed during boot.
Explanation
Recommended Action If the problem persists, issue the init system CLI command from the
switch(boot)# prompt to initialize the configuration partition. Note: This is a disruptive command.
This command will initialize the switch, reset the entire internal disk, and reformat the bootflash:
partition.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
Deletion of binary startup
OL-15956-01