Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 235

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message MODULE-2-MOD_REGFAILED: Registration failed for module [dec].
Error Message MODULE-2-MOD_SOMEPORTS_FAILED: Module [dec] reported failure on ports
[dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]).
Error Message
supported.
Error Message MODULE-2-XBAR_DIAG_FAIL: Xbar [dec] (serial: [chars]) reported failure
on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (device
error [hex]).
Error Message
failed.
OL-15956-01
The module sent the registration message notifying a failure.
Explanation
Recommended Action Collect module information by entering the show module internal all module
CLI command or by using a similar Fabric Manager procedure.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Module reported a failure in the runtime diagnostic because of a failure in some of the
Explanation
ports.
Collect module information by entering the show module internal all module
Recommended Action
CLI command or by using a similar Fabric Manager procedure.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
MODULE-2-MOD_UNKNOWN: Module type [[dec]] in slot [dec] is not
The software card ID of module [dec] is not supported by the supervisor.
Explanation
Recommended Action Collect module information by entering the show module internal all module
[dec] command or by using a similar Fabric Manager procedure. Update SPROM contents by
entering the update sprom command or by using a similar Fabric Manager procedure.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
The xbar in the slot reported a failure in the runtime diagnostic. Module manager is
Explanation
going to power cycle the module.
Collect information about the module by issuing the show module internal
Recommended Action
all xbar CLI command or by using a similar Fabric Manager procedure.'
Cisco MDS SAN-OS Release 3.0(1).
Introduced
MODULE-2-XBAR_FAIL: Initialization of xbar [dec] (serial: [chars])
Xbar reported a failure during the initialization phase and will be powered down.
Explanation
Recommended Action Collect information about the module by issuing the show module internal
all xbar <modulenumber> CLI command or by using a similar Fabric Manager procedure.
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-199