Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 277

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message PORT-5-IF_DOWN_FCSP_AUTHENT_FAILURE: Interface [chars] is down (FC-SP
authentication failure).
Error Message
being enabled).
Error Message
disabled - ficon not enabled).
Error Message PORT-5-IF_DOWN_FICON_VSAN_DOWN: Interface [chars] is down(FICON VSAN
down).
Error Message PORT-5-IF_DOWN_HW_FAILURE: Interface [chars] is down (Hardware
Failure).
Error Message PORT-5-IF_DOWN_INACTIVE: Interface [chars] is down (Inactive).
OL-15956-01
The port failed Fibre Channel Security Protocol (FC-SP) authentication with its peer.
Explanation
Check the FC-SP configuration.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
PORT-5-IF_DOWN_FICON_BEING_ENABLED: Interface [chars] is down(FICON
FICON is being enabled on the port.
Explanation
Recommended Action FICON enable takes some time. No action is required.
Introduced Cisco MDS SAN-OS Release 1.3(1).
PORT-5-IF_DOWN_FICON_NOT_ENABLED: Interface [chars] is down(Error
FICON is not enabled on the port.
Explanation
Enable FICON on the port.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
FICON is being enabled on the VSAN of this port. This is an intermediary state,
Explanation
whereby the port VSAN is being enabled to be a FICON VSAN.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
The module hardware has failed.
Explanation
Enter the show module internal all module command or use a similar Fabric
Recommended Action
Manager procedure to collect more information about the failed module.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
The port VSAN has been suspended or deleted.
Explanation
Assign a new active port VSAN to the interface.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-241