Port_Channel Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
PORT_CHANNEL Messages
This section contains the PortChannel (PORT_CHANNEL) messages.
PORT_CHANNEL-1
Error Message
[[chars]].
Error Message
Error Message
[chars] [[chars]].
Error Message
[chars].
OL-15956-01
PORT_CHANNEL-1-LC_CFG_FAILURE: configuring module [dec] failed
Module configuration failed.
Explanation
The module is automatically reset. If the problem persists, contact your
Recommended Action
customer support representative.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
PORT_CHANNEL-1-MALLOC_FAILED: cannot allocate memory (size [dec]).
There is not enough memory.
Explanation
Recommended Action
Check if the system is low on memory and reset the switch if necessary.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
PORT_CHANNEL-1-MAP_PARAM_FAILURE: mapping parameter failed for
Parameter mapping failed.
Explanation
The specified service is misbehaving. Check its status.
Recommended Action
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
PORT_CHANNEL-1-MCAST_SEND_FAILURE: failed to send multicast [chars]:
Failed to send a multicast message to all modules, usually because some module went
Explanation
down.
Enter the show port-channel consistency CLI command or use a similar
Recommended Action
Fabric Manager/Device Manager procedure to check consistency.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-257
Advertisement
Table of Contents
