Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 284

Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message PORT-5-IF_DOWN_SRC_PORT_NOT_BOUND: Interface [chars] is down (Tunnel
port src interface unbound).
Error Message PORT-5-IF_DOWN_SRC_PORT_REMOVED: Interface [chars] is down(Tunnel src
port removed).
Error Message PORT-5-IF_DOWN_SUSPENDED: Interface [chars] is down (Suspended).
Error Message PORT-5-IF_DOWN_SUSPENDED_BY_MODE: Interface [chars] is down (Suspended
due to incompatible mode).
Error Message PORT-5-IF_DOWN_SUSPENDED_BY_SPEED: Interface [chars] is down
(Suspended due to incompatible speed).
Cisco MDS 9000 Family System Messages Reference
2-248
The FCIP link port source interface is not bound.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
The link source port of this FCIP interface has been removed. The source interface with
Explanation
the IP address that matches the IP address of the bound entity is removed. This happens normally
because the module on which the source interface exists is removed.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
This interface belongs to a PortChannel and has been suspended because of an error
Explanation
while bringing it up.
Recommended Action
In most cases, you can recover by entering the shutdown and no shutdown
CLI commands or by using a similar Fabric Manager/Device Manager procedure. If this happens
again, enter the show port internal all interface command or use a similar Fabric Manager
procedure on the interface to gather more information.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
This interface belongs to a PortChannel and the operational mode of the interface is
Explanation
different from that of the PortChannel.
Recommended Action
Change the mode and the trunking mode of the PortChannel from auto and
check to ensure that the remote end of the interface also belongs to the same PortChannel.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
This interface belongs to a PortChannel and the operational speed of the interface is
Explanation
different from that of the PortChannel.
Change the speed of the PortChannel from auto and check to ensure that the
Recommended Action
remote end of the interface also belongs to the same PortChannel.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01

Advertisement

Table of Contents
loading

Table of Contents