Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 259

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
[dec].
Error Message PLATFORM-2-PFM_LC_BOOT_DEV_FAIL: Bootflash access error in Module
[dec].
Error Message
Error Message PLATFORM-2-PFM_LC_MOD_POWERED_DOWN: Module [dec] Powered Down. Module
is not supported in this chassis. (Chassis Incompatible card).
Error Message
[dec] is disabled due to incompatible platform.
Error Message
OL-15956-01
PLATFORM-2-PFM_LC_BOOT_DEV_ABSENT: No bootflash found in Module
No bootflash found.
Explanation
Put bootflash in the module and try again.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Bad bootflash/corrupted file system.
Explanation
Recommended Action Try to put in a known good bootflash in the module and try again.
PLATFORM-2-PFM_LC_BOOT_DEV_FAIL: BAD Bootflash found in Module [dec].
Bad bootflash found.
Explanation
Recommended Action Put a good bootflash in the module and try again.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation Module has been powered down because the card is not supported in this chassis.
Use the show module CLI command to see the power down reason, or use a
Recommended Action
similar Fabric Manager procedure.'
Cisco MDS SAN-OS Release 3.0(1).
Introduced
PLATFORM-2-PFM_NETBOOT_DISABLE: Netboot for supervisor module in slot
Standby supervisor failed to power up.
Explanation
Try to replace the standby supervisor.
Recommended Action
Introduced Cisco MDS SAN-OS Release 3.0(1).
PLATFORM-2-PFM_LC_NETBOOT_FAIL: Netboot for Module [dec] failed.
Netboot failed.
Explanation
Recommended Action Replace the BIOS in the module.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Cisco MDS 9000 Family System Messages Reference
2-223