Ipconf-4; Ipconf-6; Ipfc Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Error Message

IPFC Messages

This section contains the IP over Fibre Channel (IPFC) messages.
IPFC-2
Error Message
IPFC-3
Error Message
OL-15956-01
IPCONF-6-ROUTE_NOT_ACTIVE: The [chars] is not active.
The specified route is successfully configured but currently is not active.
Explanation
Recommended Action Check that the route is correct and the outgoing interface is operationally up.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
IPCONF-6-STARTING: IP configuration Manager started.
The IP configuration manager service has successfully started.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
IPFC-2-ALLOC_MEMORY: Memory allocation failed.
The service failed to allocate a block of dynamic memory.
Explanation
Check if the system is low on memory and reset the switch if necessary.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
IPFC-3-INIT_FAILED: Initialization failed. Component [chars].
Explanation The service failed to start. The failure occurred while initializing the component shown
in the error message.
Enter show processes to check the status of the other processes,. Debug the
Recommended Action
specified component.
Introduced Cisco MDS SAN-OS Release 1.3(1).
Cisco MDS 9000 Family System Messages Reference
2-133