Transport Email Mail-Server - Cisco Nexus 7000 Series Reference Manual
Nx-os system management command reference
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Configuration manual (536 pages) ,
- Hardware installation and reference manual (508 pages)
Table of Contents
Advertisement
T Commands
transport email mail-server
To configure up to five SMTP servers as the domain name server (DNS) names, IPv4 addresses, or IPv6
addresses for Call home, use the transport email mail-server command.
Syntax Description
ip-address
port
port-number
priority
priority-number
use-vrf vrf-name (Optional) Specifies the virtual routing and forwarding (VRF) name.
Defaults
None
Command Modes
Call home configuration
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History
Release
5.0(1)
Usage Guidelines
You can configure up to five SMTP servers for Call home. The VRF specified in the transport email
mail-server command is not used to send messages using HTTP. When CFS distribution is enabled,
devices that run Release 4.2 or earlier releases accept only the transport email smtp-server command
configurations while devices that run Release 5.0(1) or later releases accept both the transport email
smtp-server and transport email mail-server command configurations.
When a device accepts both the transport email smtp-server and transport email mail-server
commands, the transport email smtp-server command has a priority of 0, which is the highest. The
server specified by this command is tried first followed by the servers specified by the transport email
mail-server commands in order of priority.
This command does not require a license.
OL-25806-03
transport email mail-server
vrf-name]
Domain name server (DNS) name, IPv4 address, or IPv6 address.
(Optional) Specifies the port number. The range is from 1 to 65535. The default
port number is 25.
(Optional) Specifies the priority of the SMTP server. The range is from 1 to 100,
with 1 being the highest priority and 100 the lowest. If you do not specify a priority,
the default value of 50 is used.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
[port port-number] [priority priority-number] [use-vrf
ip-address
transport email mail-server
693
Advertisement
Table of Contents
