Show Diagnostic Result - Cisco Nexus 7000 Series Reference Manual

Show Commands

show diagnostic result

To display diagnostic test results for a module, use the show diagnostic result command.
Syntax Description
slot
test
test-id
test-name
all
detail
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.0(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to display a diagnostic test result:
switch# show diagnostic result module 6 test 6 detail
Current bootup diagnostic level: complete
Module 6: Supervisor module-1X
Diagnostic level at card bootup: complete
Test results: (. = Pass, F = Fail, I = Incomplete,
______________________________________________________________________
6) NVRAM-------------------------> .
Error code ------------------> DIAG TEST SUCCESS
OL-25806-03
show diagnostic result module {slot [test [test-id | test-name]] | all} [detail]
Diagnostic result slot number. The module slot range is from 1 to 10.
(Optional) Displays the diagnostic test selection.
(Optional) Test ID. The range is from 1 to 14.
(Optional) Test name. The test name can be any case-sensitive, alphanumeric string
up to 32 characters.
Displays the test result for all tests on all modules.
(Optional) Displays the detailed result.
Modification
This command was introduced.
U = Untested, A = Abort, E = Error disabled)
Total run count -------------> 1574
Last test execution time ----> Thu Jun 26 09:28:40 2008
First test failure time ----->
Cisco Nexus 7000 Series NX-OS System Management Command Reference
(Active)
n/a
show diagnostic result
459