Configuring The Email Server - Cisco Nexus 7000 Series Configuration Manual

Configuring Smart Call Home
Step 2
Step 3
Step 4
Step 5
Step 6
What to Do Next
Configure Smart Call Home to connect to the SMTP email server.

Configuring the Email Server

You must configure the SMTP server address for the Smart Call Home functionality to work. You can also
configure the from and reply-to email addresses.
You can configure up to five SMTP servers for Smart Call Home. The servers are tried based on their priority.
The highest priority server is tried first. If the message fails to be sent, the next server in the list is tried until
the limit is exhausted. If two servers have equal priority, the one that was configured earlier is tried first.
Command or Action
callhome
Example:
switch(config)# callhome
switch(config-callhome)#
alert-group {Configuration | Diagnostic | EEM
| Environmental | Inventory | License |
Supervisor-Hardware | Syslog-group-port |
System | Test} user-def-cmd show-cmd
Example:
switch(config-callhome)# alert-group
Configuration user-def-cmd show ip route
commit
Example:
switch(config-callhome)# commit
show callhome user-def-cmds
Example:
switch(config-callhome)# show callhome
user-def-cmds
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
Configuring the Email Server
Purpose
Enters Smart Call Home configuration
mode.
Adds the show command output to any
Smart Call Home messages sent for this alert
group. Only valid show commands are
accepted.
Commits the Smart Call Home configuration
commands.
(Optional)
Displays information about all user-defined
show commands added to alert groups.
(Optional)
Copies the running configuration to the
startup configuration.
123