Cisco Nexus 7000 Series Reference Manual page 64

cdp advertise
cdp advertise
To configure the Cisco Discovery Protocol (CDP) version supported by the device, use the cdp advertise
command. To remove the CDP configuration, use the no form of this command.
Syntax Description v1
v2
Defaults
None
Command Modes Global configuration mode (config)
if-ethernet-all configuration (config-if-ethernet-all)
if-gig-ether configuration (config-if-gig-ether)
if-eth-base (config-if-eth-base)
if-mgmt-ether (config-if-mgmt-ether)
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure the CDP version:
switch(config)# cdp advertise v2
switch(config)
This example shows how to remove the CDP configuration:
switch(config)# no cdp advertise v2
switch(config)
Related Commands Command
cdp enable
Cisco Nexus 7000 Series NX-OS System Management Command Reference
36
cdp advertise {v1 | v2}
no cdp advertise [v1 | v2]
Specifies CDP Version 1.
Specifies CDP Version 2.
Modification
This command was introduced.
Description
Enables CDP on an interface.
C Commands
OL-25806-03