Event Track - Cisco Nexus 7000 Series Reference Manual

event track

event track
To specify the event criteria for an Embedded Event Manager (EEM) applet that is run on the basis of
an object tracking subsystem report for the specified object number, use the event track command. To
remove the report event criteria, use the no form of this command.
Syntax Description
tag tag
object-id
state
up
down
any
Defaults None
Command Modes Embedded event manager
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2.(1)
4.0(1)
Usage Guidelines This command does not require a license.
Examples
This example shows how to specify that an EEM applet runs when the state of a tracked object changes:
switch# configure terminal
switch(config)# event manager applet tracking-applet
switch(config-applet)# event track 42 state down
switch(config-applet)#
Cisco Nexus 7000 Series NX-OS System Management Command Reference
170
event track [tag tag] object-id state {any | up | down}
no event track [tag tag] object-id
(Optional) Identifies this specific event when multiple events are included in the
policy.
Tracked object number. The range from 1 to 500.
Specifies that the tracked object transition causes an event to be raised.
Specifies an event is to be raised when the tracked object transitions from a down
state to an up state.
Specifies an event is to be raised when the tracked object transitions from an up
state to a down state.
Specifies an event is to be raised when the tracked object transitions to or from
any state.
Modification
Added the tag tag keywords.
This command was introduced.
E Commands
OL-25806-03