Cisco Nexus 7000 Series Reference Manual page 534

show hardware flow l2
show hardware flow l2
To display information about NetFlow hardware Layer 2 flows, use the show hardware flow l2
command.
Syntax Description monitor monitor-name
profile profile-id
vdc
vdc-id
vlan
vlan-id
detail
instance
instance
slot number
Defaults None
Command Modes EXEC mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.1(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to display detailed output information about the NetFlow Layer 2 flows:
switch(config)# show hardware flow l2 detail
D IF
Cisco Nexus 7000 Series NX-OS System Management Command Reference
506
show hardware flow l2 [monitor monitor-name | profile profile-id | vdc vdc-id | vlan vlan-id]
[detail] [instance instance] [module module]
(Optional) Specifies the name of the flow monitor. The monitor name can be
any case-sensitive, alphanumeric string up to 64 characters.
Optional) Specifies the name of the flow profile. The profile ID range is from
0 to 7.
(Optional) Specifies the virtual device context (VDC) name.
(Optional) Virtual device context ID. The range is from 1 to 16
alphanumerical string.
(Optional) Displays a VLAN.
(Optional) Displays VLAN ID. The range is from 1 to 4094.
(Optional) Displays detailed information about the flows.
(Optional) Displays information about the EARL instance.
(Optional) Displays the instance number. The range is from 1 to 2.
(Optional) Specifies the slot number. The range is from 1 to 18.
Modification
This command was introduced.
SMAC DMAC ET PktCnt
Show Commands
TCP Flags DSCP
OL-25806-03